Home > Uncategorized > Harbor Freight Hot Blade Decal Remover – Remove Foam Tape and Pin Stripping the Easy Way

Harbor Freight Hot Blade Decal Remover – Remove Foam Tape and Pin Stripping the Easy Way

The Harbor Freight Decal remover makes taking off decal, pin stripes and the like very easy to remove from your vehicle without damaging your paint. The decal remover is essentially a soldering iron with a box cutter type blade holder. Best of all, it’s less than 10 bucks! This thing works great for removing foam tape adhesive from body trim as well. No need to use harsh chemicals that might mess up your paint not to mention it takes only a fraction of the time.

Find the Hot Blade Decal Remover at Harbor Freight

Using it is pretty easy. Slide on a box cutter type blade, it comes with two blades by the way but the blades it uses can be found at Home Depot and the like. Once you have the blade on, simply plug it in and let it heat up for about 5 minutes. Be sure you are using a fresh blade so you don’t damage your paint. Once ready, hold it at about 30 degrees to the surface you are scraping and slowly start scraping. You don’t need to apply too much pressure as the hot blade will do all the work for you. The hot blade will remove most of the foam tape, decal, etc but you will have some residue left.

Removing the residue is also fairly simple with this thing so no need for chemicals. To remove the residue, unplug the device and let it cool off. Once cool, again place it at about 30 degrees to work surface and slowly remove the residue. The long handle makes it real easy to hold at the 30 degrees unlike the regular scrapers that are short and difficult to place at the necessary angle.

Conclusion, if you have a lot of decals, foam tape, pin striping, etc to remove from your vehicle then this thing is an absolute must and I highly recommend it.

Comments are closed.

TOP